Allied Telesis AR450S Bedienungsanleitung PDF herunterladen (Seite 30)

3-30 ENABLE VLAN DEBUG AR400 Series Router Software Reference

Software Release 2.6.6

C613-03079-00 REV A

ENABLE VLAN DEBUG

Syntax ENABLE VLAN={vlan-name|1..4094|ALL} DEBUG={PKT|ALL}

[OUTPUT=CONSOLE] [TIMEOUT={1..4000000000|NONE}]

where vlan-name is a unique name for the VLAN 1 to 15 characters long. Valid

characters are uppercase and lowercase letters, digits (0-9), the underscore

character (“_”), and the hyphen ( - ). The vlan-name cannot be a number or ALL.

Description This command enables debugging options for the specified VLAN or all

VLANs. The default is for all VLAN debugging to be disabled.

Enabling debug may flood the receiving Telnet session or asynchronous port

with raw data.

The DEBUG parameter specifies the debugging mode that is enabled. If PKT is

specified, packet debug mode (displaying raw ASCII packets) is enabled. If

ALL is specified, all debugging is enabled.

The OUTPUT parameter set to CONSOLE specifies that the debugging

information is to be sent to the console. By default the debugging data is sent to

the port that received the ENABLE VLAN DEBUG command. Use this option

if the command is in a script since a script is not received on a port.

The TIMEOUT parameter specifies the time in seconds when debugging is to

be enabled on the specified VLAN. This reduces the risk of the router and the

display being overloaded with too much debugging information. This value

overrides previous VLAN debugging timeout values for the VLAN, even if

they were specified for other debugging modes. If TIMEOUT is not specified,

the time out is the most recent one used in an ENABLE VLAN DEBUG

command or NONE if it had not been previously set.

Example To enable all debugging on the default VLAN, use the command:

ENABLE VLAN=default DEBUG=ALL

Related Commands DISABLE VLAN DEBUG

SHOW VLAN DEBUG

RESET SWITCH

Syntax RESET SWITCH

Description This command resets the switch module. All dynamic switch information is

cleared. All ports are reset. All counters and timers are reset to zero.

Example To reset the switch module, use the command:

RESET SWITCH

Related Commands SHOW SWITCH

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Keine Kommentare

Allied Telesis AR450S Bedienungsanleitung Seite 30