Allied Telesis AR450S Bedienungsanleitung PDF herunterladen (Seite 27)

Switching on the AR440S, AR441S and AR450S ENABLE SWITCH AGEINGTIMER 3-27

Software Release 2.6.6

C613-03079-00 REV A

The FLOW parameter specifies that flow control is disabled for the port. The

type of flow control is full-duplex flow control or half-duplex backpressure.

Example To disable ports 2, 3, and 4, use the command:

DISABLE SWITCH PORT=2-4

Related Commands ENABLE SWITCH PORT

SET SWITCH PORT

SHOW SWITCH PORT

DISABLE VLAN DEBUG

Syntax DISABLE VLAN={vlan-name|1..4094|ALL} DEBUG={PKT|ALL}

where:

■ vlan-name is a unique name for the VLAN 1 to 15 characters long. Valid

characters are uppercase and lowercase letters, digits (0-9), the underscore

character (“_”), and the hyphen ( - ). The vlan-name cannot be a number or

ALL.

Description This command disables packet debugging or all debugging for the specified

VLAN or all VLANs. The default is for all VLAN debugging to be disabled.

The DEBUG parameter specifies the VLAN debugging mode to be disabled. If

PKT is specified, the packet debug mode (displaying raw ASCII packets) is

disabled. If ALL is specified, all debugging is disabled.

Example To disable packet debugging on the default VLAN, use the command:

DISABLE VLAN=default DEBUG=PKT

Related Commands ENABLE VLAN DEBUG

SHOW VLAN DEBUG

ENABLE SWITCH AGEINGTIMER

Syntax ENABLE SWITCH AGEINGTIMER

routerDescription This command enables the ageing timer to age out dynamically learned entries

in the Forwarding Database after 304 seconds (approximately 5 minutes). The

default setting for the ageing timer is enabled.

Example To enable the ageing out of learned MAC addresses, use the command:

ENABLE SWITCH AGEINGTIMER

Related Commands DISABLE SWITCH AGEINGTIMER

SHOW SWITCH

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Keine Kommentare

Allied Telesis AR450S Bedienungsanleitung Seite 27