Allied-telesis AT-S39 Bedienungsanleitung PDF herunterladen (Seite 40)

Section II: Local and Telnet Management

4. Adjust the parameters as desired. To change a value, type its

corresponding number and, when prompted, enter the new value.

The parameters are described below.

1 - GET Community

2 - SET Community

3- Trap Community

Use these parameters to set a switch’s SNMP community strings.

4 - Trap Receiver 1

5 - Trap Receiver 2

6 - Trap Receiver 3

7 - Trap Receiver 4

Use these selections to specify the IP addresses of up to four

management workstations on your network to receive traps from

the switch.

5. After making your changes, type S to select Save Configuration

Changes.

Changes to the SNMP parameters are immediately activated on

the switch.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 241 242

Keine Kommentare

Allied-telesis AT-S39 Bedienungsanleitung Seite 40