Allied-telesis AT-S39 Bedienungsanleitung PDF herunterladen (Seite 16)

Chapter 1

Overview

The AT-S39 management software is intended for the AT-8024,

AT-8024GB, and AT-8026FC Fast Ethernet Switches. The software is used

to monitor or adjust a switch’s operating parameters. Some of the

functions that you can perform with the software include:

❑ Enable and disable ports

❑ Configure port parameters, such as port speed and duplex mode

❑ Create virtual LANs (VLANs)

❑ Create port trunks and port mirrors

❑ Assign an Internet Protocol (IP) address and subnet mask

❑ Activate and configure the Spanning Tree Protocol (STP)

❑ Configure port security

The AT-S39 management software comes pre-installed on the switch

with default settings for all operating parameters. The default settings

may be adequate for some networks and may not need to be changed. If

this is true for your network, then you can use the switch as an

unmanaged switch by simply connecting the unit to your network, as

explained in the hardware installation guide, and powering ON the

device.

Note

The default settings for the management software can be found in

Appendix A, AT-S39 Default Settings on page 238.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 241 242

Keine Kommentare

Allied-telesis AT-S39 Bedienungsanleitung Seite 16