Allied-telesis AT-S95 CLI Bedienungsanleitung PDF herunterladen (Seite 54)

Page 42

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

Default Configuration

No addresses are defined.

Command Mode

Interface Configuration (Ethernet, port-channel) mode. Cannot be configured for a range of interfaces (range

context).

User Guidelines

•

The command enables adding secure MAC addresses to a routed port in port security mode.

• The command is available when the port is a routed port and in port security mode.

• The address is deleted if the port exits the security mode or is not a routed port.

Example

In this example, the MAC-layer address 66:66:66:66:66:66 is added to port 1/g1.

show bridge address-table

The show bridge address-table Privileged EXEC mode command displays all entries in the bridge-forwarding

database.

Syntax

show bridge address-table [vlan vlan] [ethernet interface | port-channel port-channel-number]

Parameters

•

vlan — Specifies a valid VLAN, such as VLAN 1.

• interface — A valid Ethernet port.

• port-channel-number — A valid port-channel number.

Default Configuration

This command has no default configuration.

Command Mode

Privileged EXEC mode

User Guidelines

•

Internal usage VLANs (VLANs that are automatically allocated on ports with a defined Layer 3 interface) are

presented in the VLAN column by a port number and not by a VLAN ID.

• "Special" MAC addresses that were not statically defined or dynamically learned are displayed in the MAC

Address Table.

Console(config)#

interface ethernet 1/g1

Console(config-if)#

port security routed secure-address

66:66:66:66:66:66

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 347 348

Keine Kommentare

Allied-telesis AT-S95 CLI Bedienungsanleitung Seite 54