Allied-telesis AT-S95 CLI Bedienungsanleitung PDF herunterladen (Seite 134)

Page 122

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

arp

The arp Global Configuration mode command adds a permanent entry in the Address Resolution Protocol (ARP)

cache. Use the no form of this command to remove an entry from the ARP cache.

Syntax

arp ip_addr hw_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel number | out-of-

band-eth oob-interface }

no arp ip_addr {ethernet interface-number | vlan vlan-id | port-channel port-channel number | out-of-band-eth

oob-interface }

Parameters

•

ip_addr — Valid IP address or IP alias to map to the specified MAC address.

• hw_addr — Valid MAC address to map to the specified IP address or IP alias.

• ethernet interface-number — Valid Ethernet port.

• vlan vlan-id — Valid VLAN number.

• port-channel number. — Valid port-channel number.

Default Configuration

This command has no default configuration.

Command Mode

Global Configuration mode

User Guidelines

The software uses ARP cache entries to translate 32-bit IP addresses into 48-bit hardware addresses. Because

most hosts support dynamic resolution, static ARP cache entries do not generally have to be specified.

Example

The following example adds IP address 198.133.219.232 and MAC address 00:00:0c:40:0f:bc to the ARP table.

arp timeout

The arp timeout Global Configuration mode command configures how long an entry remains in the ARP cache.

Use the no form of this command to restore the default configuration.

IP Address I/F Type

------------- --------- -------

192.168.1.200/24 VLAN 1 Static

console#

console(config)# arp 198.133.219.232 00:00:0c:40:0f:bc ethernet 1/g6

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 347 348

Keine Kommentare

Allied-telesis AT-S95 CLI Bedienungsanleitung Seite 134