Allied-telesis AT-S25 Bedienungsanleitung PDF herunterladen (Seite 36)

Section II: Local and Telnet Mangement

The master switch is the switch assigned the Stack ID value of 1.

For information on Stack ID switch settings, refer to the AT-

8316F/MT, AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation

Guide.

Note

Do not connect the terminal to the RS232 port on a slave switch. To

start a local management interface on a stack, you must connect the

terminal to the RS232 port on the master switch.

2. Connect the other end of the cable to an RS-232 port on a terminal or

PC with a terminal emulator program.

3. Configure the terminal or terminal emulator program as follows:

❑ Baud rate: 9600 bps

❑ Data bits: 8

❑ Parity: None

❑ Stop bits: 1

❑ Flow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulator program.

When prompted for the user name and password, enter one of

the following options:

4. When prompted for the user name and password, enter one of the

following options.

❑ For Manager access, type manager as the user name. The default

password is “friend”.

❑ For Operator access, type operator as the user name. The default

password is “operator”.

Note

The user names cannot be changed and the passwords are case

sensitive. For instructions on how to change a password, refer to

Configuring the Management Passwords on page 49.

For information on the two access levels, refer to Management

Access Levels on page 32.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 276 277

Keine Kommentare

Allied-telesis AT-S25 Bedienungsanleitung Seite 36