Allied-telesis OmniConnect MultiModem Bedienungsanleitung

OmniConnectMult iModemInternet Access DeviceQuick Install GuidePN 613-10790-00 Rev. A

Introduction2Work sheetBefore you begin installation, use the following OmniConnect work sheet and note the listed information for use during configur

OmniConnect MultiModem Quick Install Guide3TopologyPlan your topology including the OmniConnect. The sample topology below shows the OmniConnect Multi

5Chapter 2InstallationUse this section to verify your package contents, position the device, and configure it.Verifying OmniConnect MultiModem Package

Installation6To place your LanEdge product, see the steps that follow:‰“To wall mount a LanEdge product” on page 6‰“To place a single LanEdge product

OmniConnect MultiModem Quick Install Guide7To interlock a group of LanEdge products on a desktopIf you are installing a LanEdge FastPrint Server, plac

Installation84. Pry off the interlock cap at each corner of the unit: From the side of the unit, insert the tip of a small straight-slot screwdriver i

OmniConnect MultiModem Quick Install Guide9You are now ready to configure and setup the OmniConnect. To continue, see “Verify your PC Configuration” o

Installation10Verify your PC Configuration1. Verify that your NIC and network driver are correctly installed; the Ethernet LED on the OmniConnect and

OmniConnect MultiModem Quick Install Guide11Enter PasswordAccess to the OmniStart configuration utility is protected by a password. The default passwo

Copyright ”1999 Allied Telesyn International, Corp.960 Stewart Drive Suite B, Sunnyvale CA 94086 USAAll rights reserved. No part of this publication m

Installation12External Modem SetupEach enabled modem has a Setup screen. The External Modem 1 Setup screen is used to enter the Internet Service Provi

OmniConnect MultiModem Quick Install Guide13Pressing the Dial-In Setup box allows users to dial in on a specific modem. On the OmniConnect, any one o

Installation14For telecommuters and roamers who Dial-In, you have the option of allowing PPP to assign the telecommuter (or PPP client) an IP address

OmniConnect MultiModem Quick Install Guide15The default DHCP address is 192.168.1.1.Once this information is entered, press the Next > button to pr

Installation16The Modem Parameter Verification screen verifies the configuration of the modems, the ISP information and the DNS information. Each of

OmniConnect MultiModem Quick Install Guide17Advanced Setup Options (Finish)Once the user has reached this Advanced Setup Options screen, all the minim

Installation18LanEdge PublicationsVisit our technical publications website at: www.alliedtelesyn.com Where To Find Allied Telesyn and Technical Public

OmniConnect MultiModem Quick Install Guide19For Information Regarding Allied Telesyn International, Corp.Allied Telesyn International, Corp.19015 Nort

21Appendix AOmniConnect MultiModem Installation Guide FeedbackPlease tell us what additional information you would like to see discussed in this guide

iiiRegulatory Compliance InformationAgency ApprovalsThe following agency approvals have been obtained for the LanEdge OmniConnect MutliModem in the ar

23Appendix BTechnical Support Fax OrderName__________________________________________________________________Company _________________________________

Regulatory Compliance InformationivFCC Class B StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two

OmniConnect MultiModem Quick Install GuidevOperating Conditions for the ECThe LanEdge OmniConnect MultiModem routers conforms to the Low Voltage Direc

viiTable of ContentsRegulatory Compliance Information ïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïLLLAgency Approvals...

viiiAppendix AOmniConnect MultiModem Installation Guide FeedbackïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïïëìAppendix BTechnical Support Fax Orderïïïïïïïïïïïïï

1Chapter 1IntroductionOverviewThe OmniConnect MultiModem Internet Access Device connects users on a local Ethernet LAN to the Internet over multiple (