Allied-telesis AT-S62 Bedienungsanleitung PDF herunterladen (Seite 207)

AT-S62 Command Line User’s Guide

207

For an Xmodem download, note the following:

❑ Xmodem can download a file only onto the switch on which you

started the local management session. You cannot use Xmodem

to download a file onto a switch accessed through enhanced

stacking.

❑ The new AT-S62 image file must be stored on the computer or

terminal connected to the RS232 Terminal Port on the switch.

For a TFTP download, note the following:

❑ There must be a node on your network that contains the TFTP

server software and the file to be downloaded must be stored on

the server.

❑ You should start the TFTP server software before you perform the

download command.

❑ The switch on which you are downloading the file must have an IP

address and subnet mask, such as a master switch of an enhanced

stack. You cannot use TFTP on a slave switch, since that type of

switch typically does not have an IP address. Instead, you would

need to perform the download from a local management session

of the switch using Xmodem or, alternatively switch to switch

using the REMOTESWITCH parameter.

Xmodem Download Examples

The following command uses Xmodem to download a new AT-S62

software image onto the switch:

load method=xmodem destfile=ats62.img

The destination filename must be ATS62.IMG when downloading a new

management software image.

All Xmodem transfers must be performed from a local management

session. Xmodem is not supported from a Telnet management session

or through enhanced stacking.

After you have entered the command, the management software

displays a confirmation prompt followed by another prompt instructing

you to begin the file transfer. To start the transfer, use your terminal

emulation program to specify the location of the AT-S62 software image

file stored on your workstation. The transfer protocol must be Xmodem

or 1K Xmodem.

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 419 420

Keine Kommentare

Allied-telesis AT-S62 Bedienungsanleitung Seite 207