Allied-telesis AT-8202 Bedienungsanleitung PDF herunterladen (Seite 22)

Configuring Point-to-Point (PTOP)

1-14

VCI values can range from 32 to 1023 (0-31 are reserved by

ATM Forum). A PTOP configuration can accept only one VCI.

5. Enter 0 to save the selection.

6. Bind the port service to PTOP using the

/PORTSERV/CONFIG/

CREATE command.

Note

Use the value of 34 for binding port service to PTOP for ATM.

7. Enter

1 as the VLAN number to attach to the service.

Enter Selection, 0 to save the Modification or 'q' to Quit: 0

Updating ATM configuration...

/PORTSERV/CONFIG >CREATE 34

Select ATM Service to bind

1) ATM/LEC

2) ATM/PTOP

3) ATM/TRUNK

Enter an ATM service selection >2

Select a VLAN to attach the service

Virtual LAN Information:

VLAN VLAN IP Network Admin Operation Port

ID Description Address Status Status Membership

==== ============ ========== ======== ======= ==========

1 Default VLAN(#1 1.1.1.1 ENABLE ACTIVE 1-16

Enter a VLAN selection (c to cancel)> 1

PTOP# VCC BIND StatePort Service#

===== =========== ============== ====================

0 502 Bound------ 1

1 501 Unbound---- -

Enter a ATM/PTOP selection (c to cancel)>

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Keine Kommentare

Allied-telesis AT-8202 Bedienungsanleitung Seite 22