Allied-telesis AT-8202 Bedienungsanleitung PDF herunterladen (Seite 14)

Configuring Classical IP Over ATM (CIP)

1-6

3. Enter 2 at the prompt to enable the IP address field:

4. Enter the IP address.

The IP address for this CIP service must exist on a different

connected subnet other than the VLAN on the target switch.

5. Enter the subnet mask.

6. Enter the connection type (PVC or SVC).

Enter

A for PVC or B for SVC.

7. Define the VCI value if your Step 6 entry is PVC;

Enter the ARP server ATM address if your Step 6 entry is SVC.

8. Keep the default value for MTU size.

9. Set the RIP mode.

10. Enter

0 to save the configuration.

Table 1-2 CIP Conﬁguration Parameters

Parameter Description

CIP Index Index of this CIP entity

IP Address Takes the same IP network number and subnet number of the LIS (logical IP

subnetwork)

IP Subnet Mask Subnet mask for this LIS entity

Description Optional text description of up to 31 characters

Admin Status Administrative status. Options: Enable or disable

Default: Enable

Connection Type Connection type. Options: PVC or SVC

Default: PVC

VCI Value If the connection type is PVC, the virtual channel identiﬁer value for this

connection

Arp Server ATM Address If the connection type is SVC, the ATM address of the ARP server

Mtu Size Maximum transfer unit size for data transfer for this entity

Default is 9180, as deﬁned in RFC 1577, Section 5

RIP Mode Routing internet protocol mode for this CIP entity

Default: Silent

Enter Selection, 0 to save the Modification or ‘q’ to Quit: 2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 79 80

Keine Kommentare

Allied-telesis AT-8202 Bedienungsanleitung Seite 14