Allied Telesis Rapier 16Fi-FX Installationsanleitung PDF herunterladen (Seite 102)

8 Software Reference

General PIM-DM

information

The following commands display general PIM-DM information.

PIM-DM timers Timers for PIM-DM operations have defaults that suit most networks and

should not generally be modified.

Caution Changing these timers to inappropriate values can cause PIM to

function in undesirable ways. System administrators should change these timer

values based on a sound understanding of their interaction with other devices

in the network.

If the timers need to be modified, use the command:

set pim [jpinterval={1..65535|default}]

[keepalivetime={10..65535|default}]

[pruneholdtime={1..65535|default}]

[sourcealivetime={10..65535|default}]

[srinterval={10..255|default}] [other-options...]

To list the values of the global PIM timers, use the command:

show pim timer

PIM-DM debugging To display debugging information about PIM-DM, use the command:

enable pim debug={all|assert|bsr|c-rp-adv|graft|hello|joint|

To see which debugging options are enabled, use the command:

show pim debug

This command... Shows...

show pim config CLI commands that make up the switch’s PIM configuration.

show pim counters the number of PIM messages that the switch has received and

sent, and the number of bad messages it has received.

show pim neighbour information about the neighbouring switches that PIM is aware

of.

show pim route the internal PIM routing table.

show pim staterefresh the internal State Refresh table.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 282 283

Keine Kommentare

Allied Telesis Rapier 16Fi-FX Installationsanleitung Seite 102