Allied-telesis FORMULA 8200 Bedienungsanleitung PDF herunterladen (Seite 31)

FORMULA 8200 User’s Guide

2-15

Resetting and Rebooting the Switch

You may occasionally need to reset the FORMULA 8200. You can do

this in one of three ways:

❑ The Reset button on the front panel permits you to perform a

“hardware reset,” and does not require you to use the

command line interface.

❑ The REBOOT command permits you to reset the switch via

the command line interface, either from the local console, or

from a remote location via Telnet. The current Telnet session is

disconnected by this command.

❑ The On/Off switch in the rear panel recycles the power to the

switch.

Either method initializes the hardware, loads the system software

from the ﬂash, restores the switch to the current (saved)

conﬁguration settings, and restarts the switch. Upon restart, the

POST and other diagnostic information appear on the local console,

followed by the login and password prompts.

Where to Go Next

Go to Chapter 3, Configuring the FORMULA 8200 Switch, for

information about the default switch conﬁgurations, to reconﬁgure

the switch for your particular application, or to create VLANs.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 163 164

Keine Kommentare

Allied-telesis FORMULA 8200 Bedienungsanleitung Seite 31