Allied-telesis AT-S41 Bedienungsanleitung PDF herunterladen (Seite 169)

AT-S41 User’s Guide

169

Ping Execution

To configure the ping execution settings on the switch, perform the

following procedure:

1. Click on the Tools menu tab and select Ping from the sub-menu.

The Ping Test Configuration page is displayed, as shown in Figure

53.

Figure 53 Ping Test Configuration Page

2. Adjust the parameters as desired. To change a value, enter the new

information in the data entry field. The parameters are described

below.

Destination IP Address

This command specifies the IP address of the end node you are

pinging.

Timeout Value

The length of time for which the switch will continue to send

pings if it does not receive a response. The default timeout setting

is 3 seconds.

Number of Ping Requests

Number of ping attempts the switch should make before it stops

pinging if it does not receive a response. The default number of

ping requests is 10.

3. Click the Start button.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 235 236

Keine Kommentare

Allied-telesis AT-S41 Bedienungsanleitung Seite 169