Allied-telesis AT-S41 Bedienungsanleitung PDF herunterladen (Seite 164)

AT-S41 User’s Guide

164

Configuring SNMP Community Strings and Trap IP Addresses

To configure the SNMP community strings for the switch and to assign

up to four IP addresses of management stations to receive traps from

the switch, perform the following procedure:

1. Click on the Basic Config menu tab and select SNMP Config from the

sub-menu.

The SNMP Configuration page is displayed, as shown in Figure 49.

Figure 49 SNMP Configuration Page

2. Adjust the parameters as desired. To change a value, change the

information in the data entry fields or pull-down menus and click the

Apply button. The parameters are described below.

SNMP Read Community

This parameter specifies the SNMP read community name. The

maximum length for a read community name is 20 characters.

This parameter is public.

SNMP Write Community

This command specifies the SNMP write community name. The

maximum length for a read community name is 20 characters.

This parameter is private.

Enable/Disable Authentication Trap

This command specifies a community’s trap authentication.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 235 236

Keine Kommentare

Allied-telesis AT-S41 Bedienungsanleitung Seite 164