Allied Telesis AT-SBX81XS6 Installationsanleitung PDF herunterladen (Seite 187)

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide

Section II: Installing the Chassis 187

Connecting the

DC Power Wires

with the Right

Angle Terminals

To connect the DC power wires to the positive and negative terminals on

the power supply with the right angle terminals, perform the following

procedure:

1. Prepare adequate lengths of two stranded 8 AWG power wires by

stripping them as shown in Figure 125.

Warning

Do not strip more than the recommended amount of wire. Stripping

more than the recommended amount can create a safety hazard by

leaving exposed wire on the terminal block after installation.  E10

Figure 125. Stripping the Power Wires

Note

You must use stranded wires with the terminal lugs. You may not

use solid wires.

2. Verify that the On/Off switch on the AT-SBxPWRSYS1 DC Power

Supply is in the Off position. Refer to Figure 118 on page 180.

3. Insert the power wires into the right angle terminals included with the

power supply and use a crimping tool to secure the wires to the

terminals. See Figure 126,

Figure 126. Attaching the Power Wires to the Right Angle Terminals

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 313 314

Keine Kommentare

Allied Telesis AT-SBX81XS6 Installationsanleitung Seite 187