Allied Telesis AT-SBX81XS6 Installationsanleitung PDF herunterladen (Seite 174)

100

101

Chapter 9: Powering On the Chassis

174 Section II: Installing the Chassis

3. Use an 8 mm wrench to remove the grounding post nut and washer,

shown in Figure 110, from the power supply.

Figure 110. Removing the Nut and Washer from the Grounding Post

4. Attach the grounding lug and wire to the grounding post and secure

them with the nut and washer removed in the previous step, and an 8

mm wrench.

Review the following before installing the grounding wire:

 You should angle the wire to the right so that you can open the

plastic window to access the positive and negative terminals on the

terminal block.

 You may route the cable either above or below the locking handle.

 Allied Telesis recommends tightening the nut and washer to 26

inch-lbs.

The grounding wire is illustrated in Figure 111 on page 175.

Grounding

post

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 313 314

Kommentare zu diesen Handbüchern

Keine Kommentare

Allied Telesis AT-SBX81XS6 Installationsanleitung Seite 174

Kommentare zu diesen Handbüchern