Allied-telesis SwitchBlade x8106 Bedienungsanleitung PDF herunterladen (Seite 148)

Chapter 7: Powering On the Chassis

148

Powering On the AT-SBxPWRPOE1 Power Supply

If you have not already installed the AT-SBxPWRPOE1 Power Supplies,

refer to “Installing the AT-SBxPWRPOE1 PoE Power Supply” on page 97

for installation instructions. To power on the power supplies, perform the

following procedure:

1. Identify AC sockets A and B in the recessed panel on the back panel

of the chassis, shown in Figure 97 on page 145. The sockets are for

the AT-SBxPWRPOE1 Power Supplies in slots A and B on the front

panel of the chassis.

2. Plug the AC power cord that comes with the power supply into one of

the plugs, as shown in Figure 100.

The plug should have a power supply in the corresponding slot in the

front panel. If the chassis has two AT-SBxPWRPOE1 Power Supplies,

you may power on either supply first.

Figure 100. Connecting the AC Power Cord for the AT-SBxPWRPOE1

Power Supply

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 239 240

Keine Kommentare

Allied-telesis SwitchBlade x8106 Bedienungsanleitung Seite 148