Allied-telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT Bedienungsanleitung PDF herunterladen (Seite 46)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

PN 613-50507-00 Rev C Page 46 of 224

Note - The Port State parameter returns 'unknown' for active ports.

Note - When a port is configured to auto-negotiate, the current firmware version does not

always update its Port Duplex Status parameter with the correct negotiated mode. As a result,

the port's Duplex LED may show up as green when it should really be orange and vice-versa.

Note - The Port Speed and Mode parameter of the 1000Base-X port on the AT-A15

expansion module can only be set to '1Gbps full-duplex'. Attempting to set this to any other

value will result in the error message: "The error occurred with 'Set' operation. Error: gen

Error".

Note - The Port Speed and Mode parameter of the 100/1000Base-T port on the AT-A14

expansion module can only be set to 'auto'. Attempting to set this to any other value will

result in the error message: "The error occurred with 'Set' operation. Error: gen Error".

Note - The Port Speed and Mode parameter of the 100Base-FX port on the AT-A16, AT-

A17, and AT-A19 expansion modules can only be set to '100Mbps full-duplex'. Attempting

to set this to any other value will result in the error message: "The error occurred with 'Set'

operation. Error: gen Error".

Note - Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value."

Enable

Enables the port.

Note - Expansion module ports cannot be enabled. Attempting to do so will result in the error

message: "The error occurred with 'Set' operation. Error: gen Error".

Disable

Disables the port.

Note - Expansion module ports cannot be disabled. Attempting to do so will result in the

error message: "The error occurred with 'Set' operation. Error: gen Error".

Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state, source,

and destination.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 223 224

Keine Kommentare

Allied-telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT Bedienungsanleitung Seite 46