Allied-telesis AT-S95 CLI Bedienungsanleitung PDF herunterladen (Seite 172)

Page 172

Allied Telesis

AT-S95 Management Software CLI User’s Guide

lldp hold-multiplier

The lldp hold-multiplier Global Configuration mode command specifies the amount of time the receiving device

should hold an LLDP packet before discarding it. Use the no form of this command to revert to the default setting.

Syntax

lldp hold-multiplier number

no lldp hold-multiplier

Parameters

•

number — Specifies the hold time to be sent in the LLDP update packets as a multiple of the timer value.

(Range: 2 - 10)

Default Configuration

The default configuration is 4.

Command Mode

Global Configuration mode.

User Guidelines

•

The actual time-to-live value used in LLDP frames can be expressed by the following formula:

TTL = min(65535, LLDP-Timer * LLDP-HoldMultiplier)

For example, if the value of LLDP timer is 30 and the value of the LLDP hold multiplier is 4, then the value 120

is encoded in the TTL field in the LLDP header.

Example

The following example specifies that the amount of time the receiving device should hold an LLDP packet is 10,

before discarding it.

lldp reinit-delay

The lldp reinit-delay Global Configuration mode command specifies the minimum time an LLDP port waits before

reinitializing LLDP transmissions. Use the no form of this command to revert to the default setting.

Syntax

lldp reinit-delay seconds

no lldp reinit-delay

Parameters

•

seconds — Specifies the minimum time, in seconds, an LLDP port waits before reinitializing LLDP

transmissions. (Range: 1 - 10 seconds)

Default Configuration

The default value is 2 seconds.

console(config) # lldp hold-multiplier 10

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 391 392

Keine Kommentare

Allied-telesis AT-S95 CLI Bedienungsanleitung Seite 172