Allied-telesis AT-S60 Bedienungsanleitung PDF herunterladen (Seite 144)

Chapter 13: STP Commands

142

SET STP

Syntax

set stp [default] [priority=priority]

[hellotime=hellotime] [forwarddelay=forwarddelay]

[maxage=maxage]

Parameters

default Returns all bridge and port STP settings to the default

values. This parameter cannot be used with any other

command parameter. (This parameter performs the

same function as the RESET STP command.)

priority Specifies the priority number for the bridge. This

number is used in determining the root bridge for

STP. The bridge with the lowest priority number is

selected as the root bridge. If two or more bridges

have the same priority value, the bridge with the

numerically lowest MAC address becomes the root

bridge.

The range is 0 to 61,440 in increments of 4,096. The

range is divided into sixteen increments, as shown in

the following table. You specify the increment that

represents the desired bridge priority value. The

default value is 32,768 (increment 8).

Table 3 Bridge Priority Value Increments

Increment

Bridge

Priority

Increment

Bridge

Priority

00832768

1 4096 9 36864

2 8192 10 40960

3 12288 11 45056

4 16384 12 49152

5 20480 13 53248

6 24576 14 57344

7 28672 15 61440

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 302 303

Keine Kommentare

Allied-telesis AT-S60 Bedienungsanleitung Seite 144