Allied-telesis AT-RPS8000 Bedienungsanleitung PDF herunterladen (Seite 13)

AT-RPS8000 Quick Install Guide

4. Attach the other end of the DC power cord to the R.P.S. Input

connector on the back panel of the Ethernet switch. (Refer to Figure 5

for the R.P.S. Input connector.)

5. Slide the new AT-PWR8000 module into the AT-RPS8000 unit. Use

the handle, shown in Figure 7, to guide the module into the unit.

Figure 7

Installing an Additional AT-PWR8000 Module

6. Once firmly installed, use a Phillips screwdriver to tighten the captive

screws on the module to secure it to the AT-RPS8000 unit.

7. Make sure the LED on the front of the AT-PWR8000 module is solid

green.

8. Make sure the RPS LED on the front of the Ethernet switch is solid

green to indicate a good connection to the AT-PWR8000 module.

Handle

Captive Screws

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Keine Kommentare

Allied-telesis AT-RPS8000 Bedienungsanleitung Seite 13