Allied Telesis AT-2450 Series Installationsanleitung PDF herunterladen (Seite 29)

Selecting Media Type and Duplex Mode with CardAs-

The /R= and /W= parameters are used instead of the command-

line configuration switches to create a configuration file that

setup24 can use to configure subsequent cards. You use the /W=

switch to create a file from an adapter card and the /R= switch to

configure a card by reading the configuration from the file.

When configuring cards using command-line parameters,

setup24 can configure only one AT-2450 PCI Ethernet Adapter

Card at a time. If multiple boards are to be installed, either run

CardAssistant interactively, or use a configuration file.

Boot ROM Socket

The AT-2450 PCI Ethernet Adapter Card is shipped with an

unpopulated boot ROM socket. For a diskless workstation, or for

remote or centralized booting, the card needs a boot ROM to

allow it to load the operating system over the network. Because

the boot ROM access is enabled by the physical presence of the

ROM, the boot ROM must be physically removed to enable

ROMless operation. If it is installed, your operating system must

be configured for remote boot. Consult your computer

manufacturer’s documentation.

Boot ROMs are application-specific. Allied Telesyn supplies a

range of boot ROMs for different network environments.

Contact your Allied Telesyn representative for more

information.

2450T IG.bk Page 23 Tuesday, December 29, 1998 11:58 AM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Keine Kommentare

Allied Telesis AT-2450 Series Installationsanleitung Seite 29