Allied Telesis AT-2450 Series Installationsanleitung PDF herunterladen (Seite 113)

Network Adapter Card Installation Guide

113

Running Diagnostics

The diagnostics utility is useful for viewing or changing configurations,

running diagnotics and viewing information files. This utility is located

on the CardAssistant CD or the driver installation disk.

To run diagnostics, perform the following procedure:

1. If ON, power OFF your computer and reboot into DOS mode.

Note

For Windows 98 and Me, reboot your computer with the Windows

Startup disk. The diagnostics file must be run in DOS mode.

2. Insert the CardAssistant CD or the driver installation disk into the

appropriate drive.

Note

If you are using the CardAssistant CD and your computer launches

the web browser, close or minimize the web browser window.

3. At the DOS prompt, launch the diagnostic utility for the adapter card

that you purchased.

The location of the diagnostic files on the CardAssistant CD are:

For example, if you want to run diagnostics for an AT-2500 Series

adapter card and the CD is mapped to drive D, you would enter:

D:\drivers\at2500\diag\setup25.exe

If you are using a driver installation disk, the diagnostic files are

stored in the root directory of the disk.

Adapter Card Diagnostic Location and File

AT-2400T, AT-2400BT \drivers\at2400\diag\set2400.exe

AT-2450FXT \drivers\at24_27\diag\diag.exe

AT-2500, AT-2500TX,

AT-2501

\drivers\at2500\diag\setup25.exe

AT-2700TX, AT-2700FX,

AT-2700FTX, AT-2745FX

\drivers\at24_27\diag\diag.exe

AT-2701 \drivers\at2701\diag\diag.exe

AT-2915T, AT-2930 \drivers\at29xx\diag29.exe

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 121 122

Keine Kommentare

Allied Telesis AT-2450 Series Installationsanleitung Seite 113