Allied Telesis AT-A16 Bedienungsanleitung PDF herunterladen (Seite 10)

3-10 AT-8600 Series Software Reference

Software Release 2.6.4

C613-03081-00 REV A

Port security

The port security feature allows control over the stations connected to each

switch port, by MAC address. If enabled on a port, the switch learns MAC

addresses up to a user-defined limit from 1 to 256, then locks out all other MAC

addresses. One of the following options can be specified for the action taken

when an unknown MAC address is detected on a locked port:

■ Discard the packet and take no further action,

■ Discard the packet and notify management with an SNMP trap,

■ Discard the packet, notify management with an SNMP trap and disable the

port.

To enable port security on a port, set the limit for learned MAC addresses to a

value greater than zero, and specify the action to take for unknown MAC

addresses on a locked port. To disable port security on a port, set the limit for

learned MAC addresses to zero or NONE. Port security can be enabled or

disabled on a port using the command:

SET SWITCH PORT={port-list|ALL} LEARN={NONE|0|1..256}

[INTRUSIONACTION={DISCARD|TRAP|DISABLE}]

If INTRUSIONACTION is set to TRAP or DISABLE, a list of MAC addresses

for devices that are active on a port, but which are not allowed or learned for

the port, can be displayed (Figure 3-25 on page 3-147) using the command:

SHOW SWITCH PORT={port-list|ALL} INTRUSION

A switch port can be manually locked before it reaches the learning limit by

using the command:

ACTIVATE SWITCH PORT={port-list|ALL} LOCK

Addresses can be manually added to a port locked list up to a total of 256 MAC

addresses, and the learning limit can be extended to accommodate them. Use

the command:

ADD SWITCH FILTER ACTION={FORWARD|DISCARD} DESTADDRESS=macadd

PORT=port [ENTRY=entry] [LEARN] [VLAN={vlan-name|1..4094}]

Learned addresses on locked ports can be saved as part of the switch

configuration, so that they become part of the configuration after a power

cycle. Use the command:

CREATE CONFIG=filename

If the configuration is not saved when there is a locked list for a port, the

learning process begins again after the router is restarted.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 153 154

Keine Kommentare

Allied Telesis AT-A16 Bedienungsanleitung Seite 10