Allied-telesis x610 Series Layer 3 Bedienungsanleitung PDF herunterladen (Seite 41)

x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide

System STATUS LEDs

The system STATUS LEDs on the front panel display general status

information. To locate these LEDs, see Figure 18. On the rear panel there

is a single system STATUS LED, as shown in Figure 19. See Table 9 for a

description of the system STATUS LEDs.

Figure 18. System STATUS LEDs on the Front Panel

Figure 19. System STATUS LED on the Rear Panel

Table 9. System STATUS LED Descriptions

LED State Description

FAULT Off Indicates normal operation.

Solid

Red

Indicates a fault. The switch or the operating

system sof

tware has malfunctioned. (Refer to

Chapter 5, “T

roubleshooting” on page 103 for

instructions on how to troubleshoot a problem.)

MASTER Off Indicates that the switch is not the Stack

Mas

ter.

Flashing

Green

dicates the specific stack member’s ID of the

switch

in response to the ‘show stack indicator’

command. The LED will repeatedly flash ‘n’

times in quick succession, followed by a longer

pause, where n is the stack member's ID.

Solid

Green

Indicates that the switch is the Stack Master.

STATUS

FAU LT

MASTER

RPS

PWR

RPS

READY

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 119 120

Keine Kommentare

Allied-telesis x610 Series Layer 3 Bedienungsanleitung Seite 41