Allied-telesis SwitchBlade x3106 Bedienungsanleitung PDF herunterladen (Seite 181)

SwitchBlade x3106 Installation Guide

181

Connecting the

DC Power Wires

with the Right

Angle Terminals

To connect the DC power wires to the positive and negative terminals on

the power supply with the right angle terminals, perform the following

procedure:

1. Prepare adequate lengths of two stranded 8 AWG power wires by

stripping them as shown in Figure 135.

Warning

Do not strip more than the recommended amount of wire. Stripping

more than the recommended amount can create a safety hazard by

leaving exposed wire on the terminal block after installation.  E10

Figure 135. Stripping the Power Wires

Note

You must use stranded wires with the terminal lugs. You may not

use solid wires.

2. Insert the power wires into the right angle terminals included with the

power supply and use a crimping tool to secure the wires to the

terminals. See Figure 136,

Figure 136. Attaching the Power Wires to the Right Angle Terminals

3. Verify that the On/Off switch on the AT-SBxPWRSYS1 DC Power

Supply is in the Off position. Refer to Figure 128 on page 175.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 259 260

Keine Kommentare

Allied-telesis SwitchBlade x3106 Bedienungsanleitung Seite 181