Allied-telesis Removable Power Supply and Fan Bedienungsanleitung PDF herunterladen (Seite 12)

Installation Guide

2. Plug the AC power cable into the power inlet on the PSU.

3. Connect the power cable to the main power source.

4. Check that the Run/Standby switch is set to the Run position (1). Both the

AC IN and DC OUT LEDs should be lit.

Note that when the Run/Standby switch is set to the Standby position (O),

the AC IN LED lights and the fan spins, but the DC OUT LED does not

light and the PSU does not deliver power to the device.

5. The PSU LED on the front panel of the switch lights green. If the LED does

not light green, check the Run/Standby switch. See the Hardware Reference

for more troubleshooting information.

LED

RUN/STANDBY

SWITCH

CAPTIVE

SCREW

OUT

LED

FAULT

LED

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Keine Kommentare

Allied-telesis Removable Power Supply and Fan Bedienungsanleitung Seite 12