Allied-telesis AT-S62 Bedienungsanleitung PDF herunterladen (Seite 98)

Chapter 10: File Downloads and Uploads

Section II: Advanced Operations 98

Downloading a File

This procedure explains how to download a file from a TFTP server on

your network to the switch using the web browser interface. You can

download any of the following files:

❑ AT-S62 image file

❑ Boot configuration file

❑ Public key

❑ CA certificate

Note

The public key and CA certificate are only supported on the version

of AT-S62 management software that features SSL, PKI, and SSH

security.

Caution

Installing a new AT-S62 image file will invoke a switch reset. Some

network traffic may be lost.

Note the following before you begin this procedure:

❑ You must use TFTP to download a file from a web browser

management session.

❑ There must be a node on your network that has TFTP server

software.

❑ The file to be downloaded must be stored on the TFTP server

node.

❑ You should start the TFTP server before you begin the download

procedure.

❑ The AT-S62 image file contains the bootloader for the switch. You

cannot load the image file and bootloader separately.

❑ Installing a new AT-S62 software image does not change the

current configuration of a switch (for instance, IP address, subnet

mask, and virtual LANs).

❑ The switch on which you are downloading the file must have an IP

address and subnet mask, such as a master switch of an enhanced

stack. You cannot use TFTP on a slave switch, since that type of

switch typically does not have an IP address. Rather, you would

need to perform the download from a local management session

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 334 335

Keine Kommentare

Allied-telesis AT-S62 Bedienungsanleitung Seite 98