Allied-telesis AT-S62 Bedienungsanleitung PDF herunterladen (Seite 101)

AT-S62 Web Browser Interface User’s Guide

Section II: Advanced Operations 101

Uploading a File

This procedure explains how to upload a file from the switch’s file

system to a TFTP server on your network using the web browser

interface. You can upload any of the following files:

❑ Boot configuration file

❑ Public encryption key

❑ CA certificate

❑ CA enrollment request

❑ Event log file

Note

The public key, CA certificate, and CA enrollment request are only

supported on the version of AT-S62 management software that

features SSL, PKI, and SSH security.

Note the following before you begin this procedure:

❑ You must use TFTP to upload a file using a web browser

management session.

❑ There must be a node on your network that contains the TFTP

server software.

❑ You should start the TFTP server before you begin the upload

procedure.

❑ The switch from which you are uploading a file must have an IP

address and subnet mask, such as a master switch of an enhanced

stack. You cannot use TFTP on a slave switch, since that type of

switch typically does not have an IP address. Rather, you would

need to perform the upload from a local management session of

the switch using Xmodem. For instructions, refer to the AT-S62

Menus Interface User’s Guide.

To upload a file, perform the following procedure:

1. From the Home Page, select Configuration.

2. Select the Utilities menu option.

3. Select the System Utilities tab.

The System Utilities tab is shown in Figure 28 on page 99.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 334 335

Keine Kommentare

Allied-telesis AT-S62 Bedienungsanleitung Seite 101