Allied-telesis AT-iMG6x6MOD Electronics Unit Bedienungsanleitung

613-000730 Rev CEnclosure andIntelligent Multiservice GatewaysAT-iMG6x6MOD Electronics UnitInstallation Guide

10 Chapter 2: Electronics OverviewInterfaces to the Network (Outdoor Versus Indoor Installation)The AT-iMG646MOD can be installed as part of an Outdoo

AT-iMG646MOD Installation GuideChapter 3: Installing the Gateway in the Enclosure 11Chapter 3Installing the Gateway in the EnclosureThis chapter descr

AT-iMG646MOD Installation Guide12 Chapter 3: Installing the Gateway in the EnclosureNoteStore the packaging material in a safe location. You must use

AT-iMG646MOD Installation GuideChapter 3: Installing the Gateway in the Enclosure 133. Use two of the #8-32 SEMS screws to secure the gateway to the g

AT-iMG646MOD Installation Guide14 Chapter 3: Installing the Gateway in the EnclosureConnecting the Fiber PigtailConnect the pigtail (installed as part

AT-iMG646MOD Installation GuideChapter 3: Installing the Gateway in the Enclosure 15Connecting the Coax to the Home Network (if applicable)With the HP

AT-iMG646MOD Installation Guide16 Chapter 3: Installing the Gateway in the EnclosureConnecting the Telephone WiresTo connect the telephone wires, perf

AT-iMG646MOD Installation GuideChapter 3: Installing the Gateway in the Enclosure 17CautionThe grommet must be sealed so that the unit can operate cor

AT-iMG646MOD Installation Guide18 Chapter 3: Installing the Gateway in the Enclosure6. Trim the wire tie and seal the grommet with tape and silicone s

Chapter 4: Installing the Gateway Indoors 19Chapter 4Installing the Gateway IndoorsThis chapter describes how to install the gateway in an indoor loca

Copyright © 2007 Allied Telesis, Inc. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied

AT-iMG646MOD Installation Guide20 Chapter 4: Installing the Gateway IndoorsPreparing for the InstallationTo prepare for the installation, perform the

AT-iMG646MOD Installation GuideChapter 4: Installing the Gateway Indoors 21Mount the Grounding Stud1. Put the included #8-32 x 0.5 in. SEMS screw thro

AT-iMG646MOD Installation Guide22 Chapter 4: Installing the Gateway Indoors5. Fasten the plywood to the wall, using the holes that you drilled in Step

AT-iMG646MOD Installation GuideChapter 4: Installing the Gateway Indoors 23Mount the Gateway to the Mounting Surface1. Secure the gateway to the mount

AT-iMG646MOD Installation Guide24 Chapter 4: Installing the Gateway IndoorsConnecting the Ground WireTo connect the ground wire, perform the following

AT-iMG646MOD Installation GuideChapter 4: Installing the Gateway Indoors 25Connecting the Power CordThe AT-iMG646MOD gateways are designed to be deplo

AT-iMG646MOD Installation Guide26 Chapter 4: Installing the Gateway IndoorsConnecting the Fiber Optic Cable (BD and EPON)To connect the fiber optic ca

AT-iMG646MOD Installation GuideChapter 4: Installing the Gateway Indoors 27Connecting the Coax Cable (if applicable)With the HPNA card, the AT-iMG646M

AT-iMG646MOD Installation Guide28 Chapter 4: Installing the Gateway IndoorsConnecting the T1?E1 Cable (if applicable)With the DS/T1 card, DS/E1 equipm

AT-iMG646MOD Installation GuideChapter 4: Installing the Gateway Indoors 29Connecting the Telephone WiresTo connect the telephone wires, simply connec

3Chapter 1: Preface ...

AT-iMG646MOD Installation Guide30 Chapter 4: Installing the Gateway IndoorsPrepare for Initial StartupTo complete the installation, perform the follow

AT-iMG646MOD Installation GuideChapter 5: Turn-Up and Troubleshooting 31Chapter 5Turn-Up and TroubleshootingTurn-up SequenceThe AT-iMG646MOD intellige

AT-iMG646MOD Installation Guide32 Chapter 5: Turn-Up and TroubleshootingUnderstanding the LEDs (iMG6x6MOD Unit)Figure 25. LEDs for AT-iMG646MODTable 2

AT-iMG646MOD Installation GuideChapter 5: Turn-Up and Troubleshooting 33TroubleshootingThis chapter contains information on how to troubleshoot the ga

AT-iMG646MOD Installation Guide34 Chapter 5: Turn-Up and TroubleshootingProblem: There is a problem with the telephone service.Solution: Check the fol

AT-iMG646MOD Installation Guide35Appendix ATechnical SpecificationsOrderable PartsGo to www.alliedtelesis.com, along the top menu banner select Produc

Appendix A: Technical Specifications36Environmental SpecificationsOperating Temperature:-40° C to 65° C (-40° F to 150° F)Storage Temperature:-40° C t

AT-iMG646MOD Installation Guide37Power Cord WiringTo wire the terminal block for the gateway to the terminal block for the power supply cord, refer to

Appendix A: Technical Specifications38Serial Port WiringThe CONSOLE port is an RJ45 connection (not a DB9 connection used with other Allied Telesis pr

39Appendix BCleaning Fiber Optic ConnectorsThe fiber optic connector consists of a fiber optic plug and its adapter. The end of the fiber optic cable

Contents4Using a Swab...

Appendix B: Cleaning Fiber Optic Connectors40Using a Cartridge-Type CleanerFiber optic cartridge cleaners are available from many vendors and are typi

AT-iMG646MOD Installation Guide41NoteRub the ferrule tip on the cleaning surface in one direction only.10. When you reach the end of the cleaning surf

Appendix B: Cleaning Fiber Optic Connectors42Using a SwabSpecially treated swabs (stick cleaners) are available for cleaning inside connector adapters

AT-iMG646MOD Installation Guide432. If desired, repeat step 1.3. If a fiber inspection scope is available, use the scope to inspect the connector to m

44

AT-iMG646MOD Installation Guide45613-000730 A

Appendix B: Cleaning Fiber Optic Connectors46

AT-iMG646MOD Gateway Installation Guide5Chapter 1PrefaceThis guide contains instructions on how to install the AT-iMG646MOD series intelligent Multise

Preface6Warning: Class I Equipment. This equipment must be earthed. The power plug must be connected to a properly wired earth ground socket outlet. A

AT-iMG646MOD Gateway Installation Guide7Where to Find Web-based GuidesThe installation and user guides for all Allied Telesis products are available i

Preface8Contacting Allied Telesis This section provides Allied Telesis contact information for technical support as well as sales and corporate inform

AT-iMG646MOD Installation GuideChapter 2: Electronics Overview 9Chapter 2Electronics OverviewFeaturesThe AT-iMG646MOD is part of the AT-iMG646xx serie