Allied-telesis AT-GS900/24 Bedienungsanleitung PDF herunterladen (Seite 38)

Chapter 2: Installation

5. Mount the switch in the 19-inch rack using the #10-32 Phillips screws

which are shipped with the product, as illustrated in Figure 11.

Figure 11. Rack Mounting the Switch

6. Connected the twisted pair cables to the twisted pair ports.

When connecting a twisted pair cable to a port, observe the following

guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 Check that you are using the appropriate type of twisted pair

cabling. Refer to “Twisted Pair Cabling and Distances” on page 30

for twisted pair cable specifications.

 Since the twisted pair port, when operating in Auto-Negotiation, is

Auto MDI/MDI-X, you can use either a straight-through or

crossover twisted pair cable to connect any type of network device

to a port on the switch. If you disable Auto-Negotiation on the port,

the port defaults to MDI-X.

7. Apply AC power to the switch by plugging the power cord into the AC

power connector on the back panel of the unit, as illustrated in

Figure 6 on page 33.

8. Plug the other end or the power cord into a wall outlet.

9. Verify that either the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 41 for instructions.

Note

The switch perform a self-diagnostic test upon power up. This takes

about 20 seconds to complete.

1921

Por

ern

7911 13 15 17 19 21 23

2141618 20 22

18 20 22

10 1

21416246 8

911

13 151357

17 19 21 23

POWER

10/100 LINK

ACT

1000 LINK

ACT

FDX

HDX

AT-GS900/24

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45

Kommentare zu diesen Handbüchern

Keine Kommentare

Allied-telesis AT-GS900/24 Bedienungsanleitung Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Allied-telesis AT-GS900/24