Allied-telesis AT-2973T (NetExtreme II) Bedienungsanleitung PDF herunterladen (Seite 58)

Chapter 5: Installing the Linux Drivers

Load and Run

Necessary iSCSI

Software

Components

Broadcom iSCSI Offload software suite consists of 3 kernel modules and

a user daemon. You can load the required software components either

manually or through system services.

1. Unload existing driver & kill the user daemon if necessary. Do the

following:

Manual:

rmmod bnx2i

pkill -9 bnx2id

Using system service:

service bnx2id stop

2. Load the iSCSI driver and the user daemon. Do the following:

Manual:

bnx2id

insmod bnx2i.ko

modprobe bnx2i

Using system service:

service bnx2id start

Unloading the

Linux Driver

You can unload, or remove, the Linux Driver from an RPM or TAR

installation. See the following:

 “Unloading the Driver from an RPM Installation” on page 58

 “Unloading the Driver from a TAR Installation” on page 59

Unloading the Driver from an RPM Installation

This section describes how to unload, or remove, a Linux driver from an

RPM installation.

Note

The examples used in this procedure refer to the bnx2 driver, but

also apply to the bnx2i driver.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 135 136

Keine Kommentare

Allied-telesis AT-2973T (NetExtreme II) Bedienungsanleitung Seite 58