Allied-telesis AT-2973T (NetExtreme II) Bedienungsanleitung PDF herunterladen (Seite 48)

Chapter 4: Installing the NDIS2 Driver Software

5. Edit the Autoexec.bat file by adding the following lines:

C:\ LANMAN\NETBIND.EXE

C:\LANMAN\NET START WORKSTATION

C:\LANMAN\NET USE

drive letter

: \\

server

name

resource name

6. Edit the Protocol.ini file (located in C:\LANMAN) to configure the

driver to bind with NetBEUI or any other protocols.

Here is an example:

[PROTOCOL MANAGER]

DriverName = PROTMAN$

[NETBEUI_XIF]

DriverName = netbeui$

BINDINGS = BXND20X

[BXND20X]

DriverName = "BXND20X$"

7. Restart the computer to complete the installation.

Note

The driver loads during system configuration and displays the

Broadcom banner, controller name, MAC address, IRQ number,

detected line speed, and the controller BusNum and DevNum. If the

driver fails to load, an initialization fail message is displayed. For

more information about the BusNum and DevNum keywords, see

“Using Keywords for the Drivers” on page 49.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 135 136

Keine Kommentare

Allied-telesis AT-2973T (NetExtreme II) Bedienungsanleitung Seite 48