Allied-telesis AT-MR912TX Bedienungsanleitung PDF herunterladen (Seite 43)

AT-MR912TX Installation Manual

2. Install the brackets as indicated in the following ﬁgure.

Figure 16: Installing Stacking Brackets

3. Attach the power cords of all units.

4. Use the SCSI Type II cable to connect the OUT port on the bottom unit

with the IN port on the upper unit. Continue this process until you have

connected the ﬁnal hub.

5. Do not match OUT to OUT or IN to IN when connecting the stackable

ports of any pair of hubs.

6. Repeat the preceding Steps until you have connected up to a maximum of

six AT-MR912TX hubs in a single stack

7. Check the front of each hub in the stack to make sure all green power

(PWR) LEDs are illuminated.

8. Plug all Category 5 STP/UTP cables in the 100Base-TX network ports

(RJ-45 connectors) on the front panel of each unit.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Keine Kommentare

Allied-telesis AT-MR912TX Bedienungsanleitung Seite 43