Allied-telesis AT-MCF2000M Bedienungsanleitung PDF herunterladen (Seite 45)

AT-MCF2000M Management Module Installation Guide

Setting the Chassis ID Jumper

The management module has a jumper on the circuit board

for setting the chassis ID. The AT-MCF2000M Management

Module can have a chassis ID value of 0, the default

setting, or 31.

You can leave the jumper in the default setting if the media

converter chassis will not be part of a stack or for a stack

that has just one management module.

For a stack with two AT-MCF2000M Management Modules,

you must change the chassis ID of one management

module to 31 because two management modules in the

same stack must have different chassis ID numbers.

Refer to Figure 12 or the legend printed next to the jumper

for the supported settings.

Figure 12. Setting the Chassis ID Jumper

For further information on chassis ID numbers, refer to

“Chassis ID Numbers” on page 26 or the AT-S85 and

AT-S97 Management Software Command Line Interface

User’s Guide.

AT-MCF2000M

CK M

AGEMEN

TERM

INAL

-T

RS-

232

SET

MASTER

POW

1000 LIN

ACT 10/100 LIN

KACT

FDX

HDX COL

LINK ACT

T A

CTIVITY

Chassis ID 0

(Default)

Chassis ID 31

Chassis ID Jumper

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Allied-telesis AT-MCF2000M Bedienungsanleitung Seite 45

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Allied-telesis AT-MCF2000M