Allied Telesis AT-S80 Betriebsanweisung PDF herunterladen (Seite 47)

AT-S80 Management Software User’s Guide

Section I: Using the Menus Interface 47

Returning the AT-S80 Management Software to the Factory Default

Values

This procedure returns all AT-S80 management software parameters to

their default values. The default values are listed in Appendix A, ”AT-S80

Software Default Settings” on page 237.

Caution

This procedure reboots the switch. The device does not forward

network traffic during the reboot process. Some network traffic may

be lost.

To return the AT-S80 management software to the default settings,

perform the following procedure:

1. From the Main Menu, type T to select Switch Tools.

The Switch Tools Configuration Menu is shown in Figure 9 on page 42.

2. From the Switch Tools Menu, type R to select System Reboot to start

the reboot.

The System Reboot menu is shown in Figure 10 on page 43.

3. Type O to select Set Reboot Option.

The following prompt is displayed:

Select reboot option (F/I/N)>

4. Type F or I to select one of the following:

F (Factory Default)

Resets all switch parameters to the factory default settings, including

IP address, subnet mask, and gateway address. If the DHCP client is

enabled, this selection disables it.

I (Reset to Defaults Except IP Address)

Resets all switch parameters to the factory default settings, but retains

the IP address, subnet mask, and gateway settings. If the DHCP client

is enabled, it remains enabled after this reset.

Note

Option N is described in “Rebooting the Switch” on page 42.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 241 242

Keine Kommentare

Allied Telesis AT-S80 Betriebsanweisung Seite 47