Allied Telesis AT-ANC10S/4 Installationsanleitung PDF herunterladen (Seite 33)

AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide

Installing the Standard Bracket on the AT-ANC10S/2 Adapter

If you are installing AT-ANC10S/2 adapter in a computer that requires a

standard bracket, you must replace the pre-installed low profile bracket on

the adapter with the standard bracket. To install the standard bracket,

perform the following procedure:

Note

The AT-ANC10S/4 adapter comes with the standard bracket pre-

installed. It does not come with a low profile bracket because it

cannot be installed in a computer that accommodates only low-

profile adapters.

To replace the low-profile bracket with the standard bracket, do the

following:

1. Remove the screws that attach the bracket to the adapter. See

Figure 7.

Figure 7. Removing the Low-profile Bracket

2. Fit the standard bracket onto the adapter as shown in Figure 8 on page

34 and secure with the two screws.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 129 130

Keine Kommentare

Allied Telesis AT-ANC10S/4 Installationsanleitung Seite 33