Allied Telesis AT-BMGMT Installationsanleitung PDF herunterladen (Seite 129)

SwitchBlade x8112 Chassis Switch Installation Guide

129

Applying A/C Power to the AT-SBxPWRSYS1 Power Supplies

The procedure in this section explains how to power on the AT-

SBxPWRSYS1 Power Supplies in slots C and D on the front panel. If you

have not already installed the power supplies, refer to “Installing the AT-

SBxPWRSYS1 System Power Supply” on page 83 for installation

instructions.

Note

If the chassis has both AT-SBxPWRSYS1 and AT-SBxPWRPOE1

Power Supplies, you may power on the power supplies in any order.

The power supplies may also be powered on simultaneously.

To power on the chassis, perform the following procedure:

1. Identify AC sockets C and D in the recessed panel on the back panel

of the chassis, shown in Figure 80. These sockets are for the AT-

SBxPWRSYS1 System Power Supplies in slots C and D on the front

panel of the chassis.

Figure 80. AC Sockets on the Rear Panel of the AT-SBx8112 Chassis

2. Plug the AC power cord that comes with the power supply into a plug

whose corresponding slot on the front panel has a system power

supply.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 167 168

Keine Kommentare

Allied Telesis AT-BMGMT Installationsanleitung Seite 129