Allied Telesis AT-MC105XL Installationsanleitung PDF herunterladen (Seite 23)

AT-MC105XL and AT-MC106XL Installation Guide

5. Plug the AC/DC power adapter into an appropriate AC power outlet and

insert the power plug into the DC receptacle located on the back of the

unit. Refer to Figure 7. This step does not apply if you installed the

unit in an AT-MCR12 chassis.

Figure 7 DC Connector

6. Verify that the PWR LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 15 for instructions.

7. Set the media converter to the NML (IN) position for normal network

operation.

8. Remove the dust cover from the fiber optic connector and connect the

cable to the fiber optic port. Verify that the media converter’s transmitter

port (TX) is connected to the end-node’s receiver port (RX) and that the

media converter’s receiver port (RX) is connected to the end-node’s

transmitter port (TX).

9. Connect the twisted pair cable to the twisted pair port.

12VDC

DC Receptacle

Back of Media Converter

Power Plug

AC/DC Power Adapter

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Keine Kommentare

Allied Telesis AT-MC105XL Installationsanleitung Seite 23