Allied-telesis AT-S62 Bedienungsanleitung PDF herunterladen (Seite 219)

100

101

AT-S62 Management Software Command Line Interface User’s Guide

Section II: Advanced Operations 219

UPLOAD METHOD=LOCAL

Syntax

upload method=local destfile=”

filename”

srcfile|file=appblock

Parameters

method Specifies a local upload.

destfile Specifies a filename for the AT-S62 image file. The file is

assigned this name when stored in the file system. The

name can be from 1 to 32 alphanumeric characters.

Spaces are allowed, but special characters (e.g., /, \, #,

and %) should not be used. The extension should be

“.img”. If the name contains spaces, enclose it in quotes.

srcfile or file Specifies the application block (APPBLOCK), where the

active AT-S62 image file is stored.

Description

This command copies the switch’s active AT-S62 image file from the

application block, where the active AT-S62 image is stored, to the switch’s

file system.

Note

It is unlikely you will ever need to perform this type of upload.

Note

The AT-S62 image file will take up nearly all 2 megabytes of storage

in the file system, leaving little room for other files, such as

configuration files.

The DESTFILE parameter specifies a name for the file. This is the name

given to the AT-S62 image file when it is stored in the file system. The

name should include the extension “.img”.

The equivalent SRCFILE and FILE parameters specify APPBLOCK, for

application block, where the active image file is stored.

Example

The following command uploads the active AT-S62 image from the

switch’s application block to the file system and assigns it the name “sw12

s63 image.img”:

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 655 656

Kommentare zu diesen Handbüchern

Keine Kommentare

Allied-telesis AT-S62 Bedienungsanleitung Seite 219

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Allied-telesis AT-S62