Allied-telesis AT-S39 Bedienungsanleitung PDF herunterladen (Seite 43)

Section II: Local and Telnet Management

3. From the Advanced Configuration window, type 3 to select SNMP

Configuration. The SNMP Configuration window in Figure 6 is

displayed.

Figure 6 SNMP Configuration Window

4. Adjust the parameters as desired. To change a value, type its

corresponding number and, when prompted, enter the new value.

The parameters are described below.

1 - GET Community

2 - SET Community

3- Trap Community

Use these parameters to set a switch’s SNMP community strings.

4 - Trap Receiver 1

5 - Trap Receiver 2

6 - Trap Receiver 3

7 - Trap Receiver 4

Use these selections to specify the IP addresses of up to four

management workstations on your network to receive traps from

the switch.

5. After making your changes, type S to select Save Configuration

Changes.

Changes to the SNMP parameters are immediately activated on

the switch.

Allied Telesyn AT-8024 Ethernet Switch

SNMP Configuration

1 - GET Community .............. public

2 - SET Community .............. private

3 - Trap Community ............. public

4 - Trap Receiver 1 ............ 0.0.0.0

5 - Trap Receiver 2 ............ 0.0.0.0

6 - Trap Receiver 3 ............ 0.0.0.0

7 - Trap Receiver 4 ............ 0.0.0.0

S - Save Configuration Changes

R - Return to Previous Menu

Enter your selection:

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 298 299

Keine Kommentare

Allied-telesis AT-S39 Bedienungsanleitung Seite 43