Allied-telesis AT-FS705L Bedienungsanleitung PDF herunterladen (Seite 22)

Installation

Installing the Switch on a Desktop

The AT-FS705L switch can be used on a desktop or mounted on a wall. To

wall-mount the switch, refer to “Wall-Mounting the Switch” on page 13.

To install an AT-FS705L switch on a desktop, perform the following

procedure:

1. Remove all equipment from the package and store the packaging material

in a safe location.

2. If you are installing the switch on a desktop, attach the four protective

feet to the bottom on the unit. See Figure 5. Do not attach the

protective feet if you are wall-mounting the switch.

Figure 5 Attaching the Protective Feet

3. Place the switch on a flat, secure surface (such as a desk or table) leaving

ample space around the unit for ventilation.

4. Connect the twisted pair cables to the twisted pair ports.

Caution

Power cord is used as a disconnection device: To de-energize equipment,

disconnect the power cord. ! 7

5. Power ON the switch by plugging one end of the power cord to the back of

the switch and the other end of the power cord to a power outlet.

6. Verify that the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 15 for instructions.

7. Power ON the end-nodes connected to the switch.

8. Check the LINK/ACT LEDs for each port is green. If a LED is OFF, refer

to “Troubleshooting” on page 15 for instructions.

The switch is now ready for use.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Keine Kommentare

Allied-telesis AT-FS705L Bedienungsanleitung Seite 22