Allied-telesis AR700 Series Router Bedienungsanleitung PDF herunterladen (Seite 22)

AR700 Series Router

connect them to a hub or Layer 2 switch and connect that device to the

router’s DMZ port. For information about configuring VLANs, see the

Switching chapter in the Software Reference.

3. Connecting to the WAN.

Caution If you intend to use a firewall, configure it before you activate the

WAN link.

Once initial configuration is complete, connect the router to the WAN.

Either:

• Connect a PIC port to a WAN connection (see the Port Interface Card

Quick Install Guide and Hardware Reference), or

• Use an Ethernet patch cable to connect the router’s Ethernet WAN

(ETH0) port to the Ethernet port of a WAN device (such as a modem).

AR750S Default Configuration

The default configuration file boot.cfg loads automatically when the router starts

up. This file is stored in the router’s flash memory.

The boot.cfg file on the AR725 and AR745 routers contains no significant default

configuration.

Figure 2: Default configuration file for the AR750S router

# IP Configuration

ena ip

add ip int=vlan1 ip=192.168.1.1

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Keine Kommentare

Allied-telesis AR700 Series Router Bedienungsanleitung Seite 22