Allied-telesis AT-PWR9000 Bedienungsanleitung PDF herunterladen (Seite 5)

Quick Install Guide 5

C613-04040-01 REV C

5. Place the AT-RPS9000 in its operating location.

If installing the RPS on a desktop:

• Make sure the RPS’s rubber feet are attached.

If installing the RPS in a rack:

• Remove the rubber feet.

• Attach the rack-mounting brackets.

• Mount the RPS in the rack.

For more information on selecting a site, see “Selecting a Site” on page 3.

6. Install the AT-PWR9000 power unit (if not already installed).

• In an antistatic environment, remove the AT-PWR9000 from its packing

material. Be sure to observe ESD precautions.

• On the AT-RPS9000 chassis, choose an empty bay and remove its blank

faceplate by loosening the two Phillips screws until they disengage

from the chassis (see Figure 1 on page 5).

Keep the faceplate for future use. If you remove a power unit, replace the faceplate to

prevent dust and debris from entering the AT-RPS9000 chassis and to maintain proper

airflow.

The AT-RPS9000 and other AT-PWR9000 units may overheat or be damaged by

dust and debris if bays are left uncovered.

• Slowly and carefully slide the power unit into the chassis.

• Firmly press the power unit home (until its front panel engages or

nearly engages the chassis).

• Tighten the two Phillips screws on the power unit’s faceplate.

Figure 1: Captive mounting screws on the AT-PWR9000

Handle

Captive Screws

1 2 3 4 5 6 7 8

Keine Kommentare

Allied-telesis AT-PWR9000 Bedienungsanleitung Seite 5