Allied-telesis AT-MR904TX Bedienungsanleitung PDF herunterladen (Seite 15)

AT-MR904TX Hub

Installations

This section covers the following hub installations:

❑ Standalone

❑ Cascading (Uplink)

❑ Stacking multiple hubs

Installing a Standalone Hub

To install a standalone hub, do the following:

1. Place the hub on a smooth surface.

2. Connect the power adapter DC jack to the hub and plug the adapter

into an AC outlet.

3. Connect workstations to the hub using Category 5 UTP/STP cabling.

Connect the RJ-45 connector to a port on the hub, then connect the

other end of the RJ-45 connector to the Fast Ethernet adapter in

the workstation.

Note

Distance between hub and workstation cannot exceed 100 meters

(328 ft.)

4. Set the Uplink switch to MDI-X for normal use.

5. Connect each additional device (up to four) on your network following

the previous steps. Figure 4 shows a standalone hub configuration.

MR904C1Book Page 5 Tuesday, September 2, 1997 10:28 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Keine Kommentare

Allied-telesis AT-MR904TX Bedienungsanleitung Seite 15