
Chapter 2: Installation
74
Cabling a Simplex SC Connector
To connect a fiber optic cable to a simplex SC connector, perform the
following procedure:
Warning
Class 1 laser product. 1
Warning
Do not stare into the laser beam. 2
1. Remove the dust cover from the fiber optic port, as shown in
Figure 29.
Figure 29. Removing the Dust Cover from a Simplex SC Fiber Optic Port
2. Connect the appropriate optical cable to the port, as shown in
Figure 30.
Figure 30. Connecting to the Simplex SC Fiber Optic Port
3. Connect the other end of the optical cable to the link partner.
4. Power ON the end-nodes.
5. When the connection is established, the LK LED for the fiber optic port
should show green. If the LED is OFF, refer to “Troubleshooting” on
page 83 for instructions.
587
581
Kommentare zu diesen Handbüchern