Allied Telesis AT FS709FC AT-FS709FC AT-FS709FC Installationsanleitung PDF herunterladen (Seite 14)

Installation

6. Attach the data cables and observe normal operation as indicated by the port

LEDs. Use only one Port 8, either Port 8 MDI or Port 8 MDI-X. For typical

configuration information, refer to “Cascade Configuration” on page 9.

7. Attach fiber optic cable with SC connectors to Port 9 and observe LEDs for

normal operation.

Note

Auto-negotiation for transmission mode supports full-duplex only if the

connected device also negotiates for full-duplex transmission mode. Port 9

supports full-duplex operation only.

You are finished with rackmount installation.

Standalone Configuration

In a standalone configuration, the switch supports up to 9 network nodes. Figure 3 shows a

switch connected to end stations and a server. The basic physical connection for this

configuration requires connecting one of the switch’s ports to the adapter card of an end

station.

Figure 3

AT-FS709FC Connected to End Stations

TX RX

Copper

Fiber

Full-Duplex

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Keine Kommentare

Allied Telesis AT FS709FC AT-FS709FC AT-FS709FC Installationsanleitung Seite 14