Allied-telesis AT-MC103LH Bedienungsanleitung PDF herunterladen (Seite 13)

Installation Guide

Troubleshooting

To troubleshoot your media converter, perform the following:

1. Set the unit in the Link Test mode.

2. End stations used with the media converter must operate in the same

duplex mode (either both full-duplex or both half-duplex).

3. Verify that the twisted pair cable is Category 5.

4. Verify that proper fiber cable is being used: multimode for the

AT-MC101XL and AT-MC102XL, and single mode for the AT-MC103XL

and AT-MC103LH. Refer to Table 3 on page 10 for cable specifications

5. Verify that the near end node transmitter (TX) is connected to the far end

node receiver (RX) and vice versa on the fiber segment.

Technical Specifications

Table 2 lists the media converter technical specifications.

Table 2

Media Converter Technical Specifications

Specifications

Dimensions 4.125 in W x 3.75 in D x 1.0 in H

(10.5 cm W x 9.5 cm D x 2.5 cm H)

Max. Operating temperature 0° C to 40° C (32° F to 104° F)

Max. Storage temperature -20

C to 80

C (-4° F to 176° F)

Operating altitude up to 10,000 ft (3,048 m)

Humidity 5% to 80% (noncondensing)

EMI/RFI meets FCC Class A, EN55022 Class A

Safety EN60950, UL 1950, CSA 950

EN60825

Immunity EN50082-1 Immunity Standard

Power

Input supply voltage

Max. current

Power consumption

12 V DC +/-5%

500 mA

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Keine Kommentare

Allied-telesis AT-MC103LH Bedienungsanleitung Seite 13